In this study, a new technolift lever mechanism has been designed as an alternative in order to provide ergonomics to the existing technolift clamp mechanisms used in tractors and to reduce the load applied to the mechanism. In this context, a new technolift latch mechanism has been designed considering the ergonomically holding types. This design is produced by rapid prototyping method and ergonomic design is controlled on the tractor. On the other hand, the loads on the new mechanism mounted on the vehicle were measured with the load cell and compared with the theoretical calculation result. As a result of the measurements, it was seen that experimental and theoretical results were close to each other. On the other hand, the load values indicate that this new design will operate with a 58-72% less load. This shows that the user at the head of the tractor will consume less force. However, since the developed alternative arm design will be pushed with arm / shoulder support, it is considered that it will not cause any physical problems in long-term use and will contribute to the productivity positively.