Yıl: 2020 Cilt: 8 Sayı: 2 Sayfa Aralığı: 303 - 315 Metin Dili: Türkçe DOI: 10.20290/estubtdb.659013 İndeks Tarihi: 08-01-2021

KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ

Öz:
Yapıların onarım ve güçlendirme işlerinde kimyasal ankrajlar yaygın olarak kullanılmaktadır. Hızlı ve kolay uygulanabilirolmaları nedeni ile tercih edilen kimyasal ankrajların dayanımlarına birçok parametre etki etmektedir. Bu çalışmada farklıkenar mesafesi ve derinliklerde ekilen kimyasal ankrajların çekme dayanımları incelenmiştir. 12 mm çapa sahip B420Csınıfındaki nervürlü çubuklar, 60, 100, 120, 150, 180 ve 240 mm derinliklere kenardan 60, 80, 100 ve 120 mm olacak şekildeiki bileşenli, kartuşlu yapıştırıcı ile ekilmişlerdir. Ekilen çubuklara eksenel çekme testi uygulanmış ve elde edilen yükdeplasman eğrilerinden başlangıç rijitliği, deplasman süneklik oranı ve enerji yutma kapasitesi değerleri hesaplanmıştır. ACI318 Ek-D’nin göçme modlarına göre verdiği hesap yöntemleri dikkate alınarak tasarım dayanım değerleri belirlenmiş vedeney sonuçları ile karşılaştırılarak güvenlik katsayıları bulunmuştur.
Anahtar Kelime:

-

Öz:
Chemical anchors are widely used in the repair and strengthening of buildings. Because they are fast and easy to apply, many parameters affect the strength of preferred chemical anchors. In this study, tensile strengths of chemical anchors planted at different edge distances and depths were investigated. Ribbed bars of class B420C with a diameter of 12 mm is planted with a two-component, cartridge adhesive to a depth of 60, 100, 120, 150, 180, and 240 mm from the edge to 60, 80, 100 and 120 mm. The axial tensile test was applied to the planted bars, and initial rigidity, displacement ductility ratio, and energy absorption capacity values were calculated from the obtained load-displacement curves. ACI 318 Annex-D's design strength values were determined by considering the calculation methods given according to failure modes, and safety coefficients were found by comparing with experimental results.
Anahtar Kelime:

Belge Türü: Makale Makale Türü: Araştırma Makalesi Erişim Türü: Erişime Açık
  • [1] Cook RA. Behavior of chemically bonded anchors, ASCE Journal of Structural Engineering 1993; 119; 2744-2762.
  • [2] Özen M.A. Düşük ve normal dayanımlı betonlarda epoksi ankrajların çekme davranışı. Yüksek Lisans Tezi, Pamukkale Üniversitesi Fen Bilimleri Enstitüsü, Denizli, Türkiye, 2010.
  • [3] Çalışkan Ö. Mevcut betonarme binaların dış perde duvar ile güçlendirilmesinde ankraj uygulamalarının deneysel olarak araştırılması. Doktora tezi, Eskişehir Osmangazi Üniversitesi Fen Bilimleri Enstitüsü, Eskişehir, Türkiye, 2010.
  • [4] ACI 349. Qualification of post-Installed mechanical anchors in concrete and commentary, American Concrete Insitute, Detroit, USA, 2007.
  • [5] PCI design handbook-precast and prestressed concrete, 5th ed. Chicago: Precast/Prestressed Concrete Institute; 1999.
  • [6] Darwin D, Zavaregh SS. Bond strength of grouted reinforcing bars. ACI Structural Journal 1996; 93: 486-495.
  • [7] McVay M, Cook, RA., Krishnamurthy K. Pull out simulation of post-installed chemically bonded anchors. Journal of Structural Engineering 1996; 122: 1016-1024.
  • [8] Obata M, Inoue M, Goto Y. The failure mechanism and the pull-out strength of a bond-type anchor near a free edge. Mechanics of Materials 1998; 28: 113-122.
  • [9] Lotze D, Klingner RE, Graves HL. Static behavior of anchors under combinations of tension and shear loading. ACI Structural Journal 2001; 98: 525-536.
  • [10] Zamora NA, Cook RA, Konz RC, Consolazio GR. Behavior and design of single, headed and unheaded, grouted anchors under tensile load. ACI Structural Journal 2003; 100: 222-230.
  • [11] Shirvani M, Klingner RE, Graves HL, Breakout capacity of anchors in concrete part 1: tension. ACI Structural Journal 2004; 101: 813-820.
  • [12] Strba M, Karmazinova M. Actual behavior and objective load-carrying capacity of tension steel expansion anchors to concrete. Steel Structures and Bridges 2012; 40: 440-444.
  • [13] Kim J, Jung W, Kwon M, Ju B. Performance evaluation of post-installed anchor for sign structure in South Korea. Construction and Building Materials 2013; 44: 496-506.
  • [14] Eligehausen R, Cook RA, Behavior and design adhesive bonded anchors. ACI Structural Journal 2006; 103: 822-831.
  • [15] Higgins CC, Klingner RE, Effects of environmental exposure on the performance of cast-inplace and retrofit anchors in concrete. ACI Structral Journal 1998; 95: 506-517.
  • [16] Gross JH, Klingner RE, Graves HL. Dynamic behavior of single and double near-edge anchors loaded in shear. ACI Structural Journal 2001; 98: 665-676.
  • [17] Cook RA, Konz RC. Factoring fluencing bond strength of adhesive anchors. ACI Structural Journal 2001; 98: 76-86.
  • [18] Özkul H, Mutlu M, Sağlam AR. Beton ankrajları. Sika Teknik Bülten 2001; 4.
  • [19] Bajer M, Barnat J. The glue-concrete interface of bonded anchors. Construction and Building Materials 2012; 34: 267-274.
  • [20] Epackachi S, Esmailli O, Mirghaderi SR, Behbahani AST. Behavior of adhesive bonded anchors under tension and shear loads. Journal of Constructional Steel Research 2015; 114: 269-280.
  • [21] Tondolo F. Bond behaviour with reinforcement corrosion. Construction and Building Materials 2015; 93: 926-932.
  • [22] Turker HT, Ozbay E, Balcıkanlı M. Pullout capacity development of cast in place anchors with embedded studs. Construction and Building Materials 2016; 102: 39-43.
  • [23] Richardson AE, Dawson S, Campbell L, Moore G, Mc Kenzie C. Temperature related pull-out performance of chemical anchor bolts in fibre concrete. Concrete and Building Materials 2019; 196: 478-484.
  • [24] Hlavicka V, Lubloy E. Concrete cone failure of bonded anchors in thermally damaged concrete. Construction and Building Materials 2018; 171: 588-597.
  • [25] ACI 318. Building code requirements for reinforced concrete. American Concrete Institute. Detroit, USA, 2008.
  • [26] ASTM E 488. Standard test methods for strength of anchors in concrete and masonry elements. Annual Book of ASTM Standards, American Society for Testing and Materials, Philadelphia 1984.
APA ÇALISKAN O (2020). KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ. , 303 - 315. 10.20290/estubtdb.659013
Chicago ÇALISKAN OZLEM KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ. (2020): 303 - 315. 10.20290/estubtdb.659013
MLA ÇALISKAN OZLEM KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ. , 2020, ss.303 - 315. 10.20290/estubtdb.659013
AMA ÇALISKAN O KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ. . 2020; 303 - 315. 10.20290/estubtdb.659013
Vancouver ÇALISKAN O KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ. . 2020; 303 - 315. 10.20290/estubtdb.659013
IEEE ÇALISKAN O "KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ." , ss.303 - 315, 2020. 10.20290/estubtdb.659013
ISNAD ÇALISKAN, OZLEM. "KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ". (2020), 303-315. https://doi.org/10.20290/estubtdb.659013
APA ÇALISKAN O (2020). KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ. Eskişehir Teknik Üniversitesi Bilim ve Teknoloji Dergisi b- Teorik Bilimler, 8(2), 303 - 315. 10.20290/estubtdb.659013
Chicago ÇALISKAN OZLEM KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ. Eskişehir Teknik Üniversitesi Bilim ve Teknoloji Dergisi b- Teorik Bilimler 8, no.2 (2020): 303 - 315. 10.20290/estubtdb.659013
MLA ÇALISKAN OZLEM KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ. Eskişehir Teknik Üniversitesi Bilim ve Teknoloji Dergisi b- Teorik Bilimler, vol.8, no.2, 2020, ss.303 - 315. 10.20290/estubtdb.659013
AMA ÇALISKAN O KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ. Eskişehir Teknik Üniversitesi Bilim ve Teknoloji Dergisi b- Teorik Bilimler. 2020; 8(2): 303 - 315. 10.20290/estubtdb.659013
Vancouver ÇALISKAN O KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ. Eskişehir Teknik Üniversitesi Bilim ve Teknoloji Dergisi b- Teorik Bilimler. 2020; 8(2): 303 - 315. 10.20290/estubtdb.659013
IEEE ÇALISKAN O "KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ." Eskişehir Teknik Üniversitesi Bilim ve Teknoloji Dergisi b- Teorik Bilimler, 8, ss.303 - 315, 2020. 10.20290/estubtdb.659013
ISNAD ÇALISKAN, OZLEM. "KİMYASAL ANKRAJLARDA KENAR MESAFESİ VE GÖMME DERİNLİĞİNİN ETKİSİ". Eskişehir Teknik Üniversitesi Bilim ve Teknoloji Dergisi b- Teorik Bilimler 8/2 (2020), 303-315. https://doi.org/10.20290/estubtdb.659013