Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle

Aniekan Essienubong IKPE, (University of Benin, Department of Mechanical Engineering, Benin City, Nigeria)
Ekom ETUK, (University of Benin, Department of Production Engineering, Benin City, Nigeria)
Akanu-ıbiam NDON (Akwa Ibom State University, Department of Civil Engineering, Mkpat Enin, Nigeria)
Gazi University Journal of Science Part A: Engineering and Innovation
1 0
Yıl: 2021 Cilt: 8 Sayı: 1 Sayfa Aralığı: 81 - 93 Metin Dili: İngilizce İndeks Tarihi: 29-07-2022

Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle

Öz:
Q-Blade simulation tool was employed in modal analysis of horizontal axis wind turbine bladewith three distinct configurations (with spar, no spar and solid) to determine the configuration withadequate structural integrity under aerodynamic loading conditions. The blade configurations wereanalysed in four different modes based on the flapwise and edgewise response of the blade toaerodynamic loads/forces, and the corresponding modal eigenfrequencies were evaluated.Bending due to combined effects of flapwise and edgewise modal frequencies on the blade werealso evaluated at different rotor blade speeds ranging from 2-8m/s. It was observed that the solidblade configuration had the least modal eigenfrequencies for both flapwise and edgewise responsein all the four modes as follows: 22.03 and 62.60 Hz in mode 1, 58.0 and 212.8 Hz in mode 2,122.6 and 600.6 Hz in mode 3, 194.4 and 1118.9 Hz in mode 4. The rotor blade configuration withNo spar had the highest modal eigenfrequencies for both flapwise and edgewise response in all thefour modes followed by the blade configuration with spar. Bending of the rotor blade due tocombined effects of flapwise and edgewise modal frequencies at the aforementioned blade speedswere also highest in blade configuration with No spar and lowest in the solid blade configuration.The low modal eigenfrequencies and low bending values on the solid blade configuration implyhigh stiffness and strength but with additional mass, which is why 6000 series aluminium wasselected in order to minimize the extra weight.
Anahtar Kelime: Eigenfrequencies Rotor Blade Bending Modal Analysis Wind Turbine Failure

Belge Türü: Makale Makale Türü: Araştırma Makalesi Erişim Türü: Erişime Açık
  • Bagherpoora, T., & Xuemin, L. (2017). Structural Optimization Design of 2MW Composite wind turbine blade. Energy Procedia 105, 1226-1233.
  • Bhatt, P. (2009). Maximum Marks Maximum Knowledge in Physics Class X, Second Edition. Allied Publishers Private Limited, New Delhi, ISBN: 978-81-8424-444-1.
  • Brain, J. S., & Mark, H. R. (1999) Experimental Modal Analysis. Vibration Technology Inc, Jamestown, California, 95327.
  • Brøndsted, P., & Nijssen, R. (2013). Advances in Wind Turbine Blade Design and Materials. Woodhead Publishing, Oxford, UK, pp. 484.
  • Chaudhari, N. B. (2014). Dynamic Characteristics of Wind Turbine Blade. International Journal of Engineering Research and Technology, 3(8), 1-6.
  • Chen, C. P., & Kam, T. Y. (2011). Failure Analysis of Small Composite Sandwich Turbine Blade Subjected to Extreme Wind Load. Procedia Engineering, 14, 1973-1981.
  • Efe-Ononeme, O. E., Ikpe, A. E., & Ariavie, G. O. (2018). Modal Analysis of Conventional Gas Turbine Blade Materials (UDIMET 500 and IN738) For Industrial Applications. Journal of Engineering Technology and Applied Sciences, 3(2), 119-133.
  • Etuk, E. M., & Ikpe, A. E. (2020a). 3D Modelling of the Wind Flow Trajectories and Its Characteristic Effects on Horizontal Axis Wind Turbine at Different Wind Regimes. Journal of International Environmental Application and Science, 15(2), 68-80.
  • Etuk, E. M., Ikpe, A. E., & Adoh, U. A. (2020b). Design and Analysis of Displacement Models for Modular Horizontal Wind Turbine Blade Structure. Nigerian Journal of Technology, 39(1), 121-130.
  • Garolera, A. C., Madsen, S. F., Nissim, M., Myers, J. D., & Holboell, J. (2016). Lightning Damage to Wind Turbine Blades from Wind Farms in the US. IEEE Transactions on Power Delivery, 31(3), 1043-1049.
  • Higham, N. J., Mackey, D. S., Tisseur, F., & Garvey, S. D. (2008). Scaling, Sensitivity and Stability in the Numerical Solution of Quadratic Eigenvalue Problems. International Journal for Numerical Methods in Engineering, 73, 344-360.
  • Ikpe, A. E., Owunna, I., Ebunilo, P. O., & Ikpe, E. (2016a). Material Selection for High Pressure (HP) Compressor Blade of an Aircraft Engine. International Journal of Advanced Materials Research, 2(4), 59- 65.
  • Ikpe, A. E., Owunna, I., Ebunilo, P. O., & Ikpe, E. (2016b). Material Selection for High Pressure (HP) Turbine Blade of Conventional Turbojet Engines. American Journal of Mechanical and Industrial Engineering, 1(1), 1-9.
  • Ikpe, A. E., Efe-Ononeme O. E., & Ariavie, G. O. (2018). Thermo-Structural Analysis of First Stage Gas Turbine Rotor Blade Materials for Optimum Service Performance. International Journal of Engineering and Applied Sciences, 10(2), 118-130.
  • Ikpe, A. E., Ndon, A. E., & Etuk, E. M. (2019). Response Variation of Chladni Patterns on Vibrating Elastic Plate under Electro-Mechanical Oscillation. Nigerian Journal of Technology, 38(3), 540-548.
  • Ivan, B., Marco, A., & Mathias, L. (2014). Physically and Geometrically Non-linear Vibrations of Thin Rectangular Plates. International Journal of Non-Linear Mechanics 58, 30-40.
  • Larsen, G. C., Hansen, M. H., Baumgart, A., & Carlen, I. (2002). Modal Analysis of Wind Turbine Blades. Denmark, Forsknings center Risoe, Risoe-R, 1181, ISBN: 87-550-2697-4.
  • Marulo, F., Petrone, G., Alessandro, V. D., & Lorenzo, E. D. (2014). Operational modal analysis on a wind turbine blade. Proceedings of ISMA2014 and USD2014, 783-798.
  • Mishnaevsky, L., Branner, K., Petersen, H. N., Beauson, J., McGugan, M., & Sørensen, B. F. (2017). Materials for Wind Turbine Blades: An Overview. Materials, 10(1285), 1-24.
  • Mouhsine, S. E., Oukassou, K., Ichenial, M. M., Kharbouch, B., & Hajraoui, A. (2018). Aerodynamics and Structural Analysis of Wind Turbine Blade. Procedia Manufacturing, 22, 747-756.
  • Okokpujie, I. P., Okonkwo, U. C., Bolu, C. A., Ohunakin, O. S., Agboola, M. G., & Atayero, A. A. (2020). Implementation of multi-criteria decision method for selection of suitable material for development of horizontal wind turbine blade for sustainable energy generation. Heliyon, 6, e03142.
  • Owunna, I., Ikpe, A. E., Satope, P., & Ikpe E. E. (2016). Experimental Modal Analysis of a Flat Plate Subjected to Vibration. American Journal of Engineering Research, 5(6), 30-37.
  • Pedersen, H. B., & Kristensen, O. J. D. (2003). Applied modal analysis of wind turbine blades: Modal analysis on loaded and unloaded blade, Denmark. Forsknings center Risoe, Risoe-R, 1388(7), 41-46.
  • Tartibu, L. K., Kilfoil, M., & Vandermerwe, A. J. (2012). Vibration Analysis of a Variable Length Blade Wind Turbine. International Journal of Advances in Engineering and Technology, 4(1), 630-639.
  • Taware, G. B., Mankar, S. H., Ghagare, V. B., Bharambe, G. P., & Kale, S. A. (2016). Vibration Analysis of a Small Wind Turbine Blade. International Journal of Engineering and Technology, 8(5), 2121-2126.
  • Soriano, L. A., Yu, W., & Rubio, J. J. (2013). Modelling and Control of Wind Turbine. Mathematical Problems in Engineering, 982597, 1-13.
  • Vermeer, L., Sorensen, J., & Crespo, A. (2003). Wind Turbine Wake Aerodynamics. Progress in Aerospace Sciences, 39, 467-510.
  • Yasuda, Y., Yokoyama, S., Minowa, M., & Satoh, T. (2012). Classification of Lightning Damage to Wind Turbine Blades. IEEE J. Trans, 7, 559-566.
APA Ikpe A, Etuk E, Ndon A (2021). Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle. , 81 - 93.
Chicago Ikpe Aniekan,Etuk Ekom,Ndon Akanu-Ibiam Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle. (2021): 81 - 93.
MLA Ikpe Aniekan,Etuk Ekom,Ndon Akanu-Ibiam Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle. , 2021, ss.81 - 93.
AMA Ikpe A,Etuk E,Ndon A Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle. . 2021; 81 - 93.
Vancouver Ikpe A,Etuk E,Ndon A Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle. . 2021; 81 - 93.
IEEE Ikpe A,Etuk E,Ndon A "Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle." , ss.81 - 93, 2021.
ISNAD Ikpe, Aniekan vd. "Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle". (2021), 81-93.
APA Ikpe A, Etuk E, Ndon A (2021). Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle. Gazi University Journal of Science Part A: Engineering and Innovation, 8(1), 81 - 93.
Chicago Ikpe Aniekan,Etuk Ekom,Ndon Akanu-Ibiam Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle. Gazi University Journal of Science Part A: Engineering and Innovation 8, no.1 (2021): 81 - 93.
MLA Ikpe Aniekan,Etuk Ekom,Ndon Akanu-Ibiam Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle. Gazi University Journal of Science Part A: Engineering and Innovation, vol.8, no.1, 2021, ss.81 - 93.
AMA Ikpe A,Etuk E,Ndon A Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle. Gazi University Journal of Science Part A: Engineering and Innovation. 2021; 8(1): 81 - 93.
Vancouver Ikpe A,Etuk E,Ndon A Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle. Gazi University Journal of Science Part A: Engineering and Innovation. 2021; 8(1): 81 - 93.
IEEE Ikpe A,Etuk E,Ndon A "Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle." Gazi University Journal of Science Part A: Engineering and Innovation, 8, ss.81 - 93, 2021.
ISNAD Ikpe, Aniekan vd. "Modal Analysis of Horizontal Axis Wind Turbine Rotor Blade with Distinct Configurations under Aerodynamic Loading Cycle". Gazi University Journal of Science Part A: Engineering and Innovation 8/1 (2021), 81-93.
Sayfa Oluşturulma Tarihi
25-04-2024 5:6

İLETİŞİM

TÜBİTAK ULAKBİM TR Dizin

Yüzüncüyıl, İşçi Blokları Mahallesi

Muhsin Yazıcıoğlu Caddesi No:51/C

06530 Çankaya / ANKARA +90 (312) 298 92 00

trdizin@tubitak.gov.tr

TÜBİTAK ULAKBİM Ulusal Akademik Ağ ve Bilgi Merkezi Cahit Arf Bilgi Merkezi © Tüm Hakları Saklıdır. Gizlilik Politikası Kullanım Şartları